|
The push rod supports casting was trued up, starting with
the end opposite the cast lug. Top surfaces were trued to the
as cast bottom surface. The bottom surface was then trued to the
machined top face. Mounting holes were located and drilled before removing the part from the vise. |
|
The push rod supports have been
reinstalled in the vise with the bottom surface facing up. The Y direction center line
was picked up using the drill bit and drilled holes. |
|
The push rod groove was cut before the
brackets were separated to help insure proper location of the groove in each bracket. |
|
A groove
for the governor lever is added using the slitting saw. |
|
After all features were machned,
the push rod supports were separated using the slitting saw. |